Figure 9.
Conveyor Idler Sprocket Assembly.
10. Removal, Disassembly,
Assembly,
and
Installation
of
the
Dead
End
Section
Assembly.
NOTE: All item numbers refer to Figure 10.
NOTE: The following procedures apply to both dead end section assemblies.
Remove the dead end section assembly by folding up the conveyor dead end section
(1) and removing the two cotter pins (2), flat washers (3), and one connecting link
(4) from each side.
Separate the dead end section from the adjoining conveyor
section.
Figure 10.
Conveyor Assembly.
NOTE: All item numbers refer to Figure 11.
14
OD1737
Previous Page
