o Attach the S-hook (7) to the chain (6) and bend the S-hook closed.
Attach
the other end of the chain to the quick-release pin (5) and bend the S-hook
closed.
o Slide the end of the lower support section (8) into the upper support section
(10) and align the spring pin holes. Install the spring pin (9) in the lower
support section.
o Install the quick-release pin (5), chain (6), and S-hook (7) on the collar
(3) with a screw (4).
o Install the washer (2) and the support locking handle (1) on the collar (3).
Figure 6.
Upper Support, Quick-Release Pin and Handle.
7.
Removal and Installation of the Drive-End Section Coupling Sprocket, Pillow
Blocks, and Drive Sprocket Assembly.
NOTE: All item numbers refer to Figure 7.
Prior to starting this maintenance task, the following components of the conveyor
assembly must be removed:
o Conveyor chain.
o Drive end section roller assembly.
With the components removed, begin the removal process using the following steps:
o Remove the two screws (2), flat washers (3), lockwashers (4), and chain guard
(1).
9
OD1737