o Remove the four cable support clips (4) from the upper rear door of the
vehicle by removing the screw (5) from each cable support clip.
Figure 3. Conveyor Support Strap and
Cable Support Clips.
4.
Removal and Installation of the Conveyor Supports and Support Brackets.
This maintenance task requires two people.
NOTE: All item numbers refer to Figure 4.
NOTE: This procedure applies to both conveyor supports and brackets.
WARNING
DO NOT attempt to remove the conveyor supports
while the conveyor is in the deployed position.
Ensure the conveyor is in the stowed position
(TM 9-2350-267-10).
The removal process is as follows:
o Slide the lower support (1) into the upper support (2) and secure it with the
quick-release pin (3). While an
6
OD1737
Previous Page
