NOTE: This procedure (for both support cables) is performed with the conveyor fully
deployed (TM 9-2350-267-10).
o Lower the upper rear door to the 45 stop (TM 9-2350-267-10).
o Remove the locking pin (1) from the retaining pin (2). Release the upper end
of the cable (3) by removing the retaining pin (2) from the door bracket (4).
Figure 2.
Conveyor Support Cables.
3.
Removal and Installation of the Conveyor Support Strap Assembly and Cable
Support Clips.
NOTE: All item numbers refer to Figure 3.
Accomplish removal by using the following steps:
o Unhook the strap assembly hook (1) from the strap stud (2). Turn the strap
stud counterclockwise and remove it from the ceiling of the vehicle.
o Turn
the
strap
stud
(3),
with
the
strap
assembly
attached
(1),
counterclockwise and remove it from the ceiling of the vehicle.
5
OD1737
Previous Page
