o Roughen the underside surface of the new wear strips (11, 13, and 14). Apply
adhesive (Item 1, Appx.
D) to the roughened side of the wear strips and
mounting surfaces of the conveyor section (1).
Allow the adhesive to dry
until tacky before assembly.
o Apply a thin coat of adhesive rubber (Item 4, Appx.
D) to the new rubber
strip (15) and the mounting surface of the dead end section.
Allow the
adhesive to dry until tacky before installing the rubber strip. Install the
new rubber strip to the mounting surface of the dead end section (1).
o Using two screws (21), flat washers (22), and new lockwashers (23), install
the latch (24) on the side of the dead end section (1).
o Install the two pins (16) to the dead end section (1) and secure them using
two screws (17), four flat washers (18), nuts (20), and new lockwashers (19).
o Apply sealing compound (Item 53, Appx. D) to the threads of the new screws
(10 and 12).
Install the new wear strips (11, 13, and 14) to the mounting
surfaces of the dead end section (1) using the new screws.
Figure 11.
Conveyor Dead End Section.
o Position and align the flipper block (6) with the holes in the dead end
section (1). Drive the support bar (7) into position, securing it by using
two flat washers (9)
16
OD1737
Previous Page
