Remove the Accessory Gearbox. Use the same procedures given in part
A of this lesson to remove the accessory gearbox from the forward
engine module.
Remove the Thermocouple Branched Wiring Harness 3W106.
To remove
this wiring harness, you remove the two screws (2) lockwashers (3),
and washers (4) from one side of the cable duct (5) and two
electrical tie-down straps (6).
Then, disconnect the three plug
connectors (8) from the receptacle connectors (9), cut off any
electrical tie-down straps (7), and lift the harness (1) from the
powerpack (fig. 1-42).
Figure 1-42.
Thermocouple Branched Wiring Harness 3W106.
Remove the Maintenance Indicator Branched Wiring Harness 3W107. To
remove this wiring harness, you must remove the two screws (1)
lockwashers (2), and washers (3) from one side of the cable duct
(4) and two electrical tie-down straps (5).
Then cut off any
electrical tie-down straps (fig. 1-43).
Figure 1-43.
Maintenance Indicator Branched Wiring
Harness 3W107.
35
OD1707
Previous Page
