forward dolly (9) has moved all the way forward. After you have the
forward dolly correctly positioned, lower the module on the dolly
until the four cables (10) have slack, and remove the gearshaft (12)
and the preformed packing (11).
After you have removed the
preformed packing, install the gearshaft in the gearbox drive
splines (13) (fig. 1-40).
Figure 1-40.
Lowering the Accessory Gearbox Module.
NOTE:
The following callout numbers refer to Figure 1-41.
Remove the Accessory Gearbox Module from the Maintenance Stand (2).
Center the hoist hook (3) over the Accessory gearbox module (1) and
unhook the sling (4) from the chain hoist hook (5).
Then, attach the sling shackle (4) on the hoist hook (3). Using the
hoist to raise and lower the accessory gearbox module, set it on two
wood blocks (6) and cover all openings with tape.
Install the Two Retaining Pins on the Forward Module (8).
If the
retaining pin (7) has grooves (10), push one pin completely through
the closest hole (12) and part way through the other hole (13).
Then, put one lockpin (14) through the hole in the mount (15) until
it touches the
32
OD1707
Previous Page
