Remove the Pressure Fluid Filter Double Angle Bracket. Remove the
screw (4), washer (5), and self-locking nut (6) securing the clamp
(2), and move the clamp and harness (3) aside. Then, you remove the
two screws (7) and washers (8) from the bracket (1) and lift the
bracket from the powerpack (fig. 1-48).
Figure 1-48.
Pressure Fluid Filter Double Angle Bracket.
Remove the Reduction Gear Hose and the Flange to Hose Elbow
(Reduction Gear). Remove the two hex screws (2) on the hose clamps
(3) and slide the hose (1) off the elbow (4).
Then, remove the
clamps from the hose, bend the hose, and gently slide the hose off
the tube (5) (fig. 1-49).
39
OD1707
Previous Page
