Remove the Ignition Electrical lead. Looses and remove the lead (1)
from the spark igniter (2) (fig. 1-52).
NOTE:
Spark may not occur when grounding the lead (1) (fig. 1-52).
Then, you must touch the lead (1) against the spark igniter housing
(3) to ground the lead.
Loosen and remove the lead from the
ignition exciter receptacle connector (4).
Next, remove the lead
from under the collector tube assembly (5) and from the powerpack
(fig. 1-52).
Figure 1-52.
Ignition Electrical Lead.
Remove the Tube Assembly (No. 5 and 6 Bearing).
Before you can
remove this tube assembly, you must remove the tube assembly (bottom
of inlet guide vane actuating cylinder) and the tube assembly (top
of inlet guide vane actuating cylinder). You use the same procedure
give in part A of this lesson of this to remove both of the tube
assemblies.
42
OD1707
Previous Page
