Figure 22: Drive End Section

Maintenance And Troubleshooting Of The Conveyor Assembly On The M922
Page Navigation
28

(15),

flat

washers

(16),

and

brackets (17).

Figure 22.

Drive End Section.

To assemble and install the drive end section assembly, reverse the disassembly and

removal procedures.

20. Removal and Installation of the Conveyor Drive End Section Assembly Chain

Guards and Side, Chain Return, and Bottom Wear Strips.

NOTE: All item numbers refer to Figure 23.

The drive end section wear strip is removed by following the procedure outlined:

o Remove the chain assembly.

DO NOT remove the chain from around the take up

end section.

o Remove the ten screws (1) from each side wear strip (2).

Pry up and remove

the wear strips from the drive end section.

OD1737

Index