o Unscrew and remove the support stand stop (14).
Loosen the two setscrews
(15) securing the support (16) to the support stand (11) and remove the top
support.
Figure 25.
Conveyor Assembly Support Stand.
To install the conveyor assembly and support stand reverse the removal process.
22. Removal and Installation of the Conveyor Assembly Hydraulic Motor.
Review all the hydraulic notes and warnings for the removal of the conveyor
assembly and support stand because they apply to this maintenance task also.
The conveyor hydraulic motor is removed by following the process outlined:
NOTE: All item numbers refer to Figure 26.
NOTE: Tag hydraulic line for proper installation.
o Disconnect the two motor hydraulic lines (1) from the adapters (2).
o Loosen the setscrew (3) in the coupling sprocket (4).
32
OD1737
Previous Page
