NOTE: Be careful when deploying the conveyor without springs attached.
Deploy the
conveyor slowly.
o Deploy the conveyor slowly.
DO NOT attach the support arms (TM 9-2350-267-
10); place a support under the conveyor.
o Disconnect the electrical wiring harness connectors at the drive end section.
Remove the wire harness and clamp from the support stand.
o Disconnect the hydraulic lines (2) from the conveyor motor (3).
Figure 24.
Conveyor Assembly and Support Stand.
NOTE: All item numbers refer to Figure 25.
o Remove the bolt (4), nut (5), and three washers (6).
o Disconnect the conveyor support cables by removing the quick-disconnect pins.
This task is separate maintenance task.
o Lift and remove the conveyor assembly from the vertical support and remove it
from the work area.
o Remove the screw (7), lockwasher (8), flat washer (9), and strap (10) that
secure the two hydraulic hoses to the support stand (11).
Remove the four
bolts (12), lockwashers (13), and support stand.
31
OD1737
Previous Page
