wear strips and mounting surfaces of the center section (3).
Allow the
adhesive to tack dry approximately five minutes before installation.
Apply
sealing compound (Item 53, Appx. D) to the threads of the screws (1).
o Complete the installation process by reversing the removal procedure.
Figure 19.
Conveyor Center Section Assembly Wear Strips.
18. Removal and Installation of the Conveyor Center Section Assembly Side, Chain,
and Bottom Wear Strips.
NOTE: The following procedures apply to all four hinge assemblies.
WARNING
DO NOT remove more than one hinge at a time. The conveyor
could collapse and injure personnel.
DO NOT operate or
stow the conveyor with hinge removed.
NOTE: All item numbers refer to Figure 20.
The conveyor hinge assembly is removed by following the procedure outlined:
NOTE: This step is for the left side hinge removal only.
Omit this step if the
right side hinge is being removed.
25
OD1737
Previous Page
