Removal, Disassembly, Assembly, and Installation of the Hydraulic Control Panel Assembly

Introduction, Maintenance, And Troubleshooting of the Primary/Backup Hydraulic System
Page Navigation
22

components replaced, the assembly process for the hydraulic reservoir can

be started.

o To assemble the reservoir, you reverse the disassembly

procedures. Use new lockwashers and packings as necessary.

o During the assembly process, apply pipe sealant (Item 57, Appx.

D, TM 9-2350-267-20) to all male pipe threads.

CAUTION

ENSURE THE INSIDE OF THE HYDRAULIC RESERVOIR (11) IS

CLEAN AND FREE OF FOREIGN MATERIAL PRIOR TO THE

INSTALLATION OF THE COVER PLATE ASSEMBLY.

o The torque specification for the screws (18) is 22 to 26 inch

pounds.

With the hydraulic reservoir assembled, and all components removed,

inspected, and defective ones replaced, the installation process for the

hydraulic reservoir can begin.

o To install the hydraulic reservoir, you reverse the removal

procedures. Use new lockwashers and packings as necessary.

o During the installation process apply pipe sealant (Item 57,

Appx. D, TM 9-2350-267-20) to all male pipe threads.

o When you install all components and all connections tight, refer

to LO 9-2350-267-12 for the hydraulic fluid specification and

system refill procedures.

Removal, Disassembly, Assembly, and Installation of the Hydraulic

NOTE:

Tag all electrical leads, hydraulic

tubes,

and

hoses

for

identification at installation.

NOTE:

All item numbers refer to Figures 14F through 23F.

OD1703

Index