At the other end of the control, align the control (1) with
the slot (3) in the bracket (2), move the nut (4) above the
bracket and slide the control in the slot. Screw the nut down
on the control, tight against the bracket. Then push in the
button (5) in the pin (6) and remove the pin, align the holes
in the end of the control with the hole in the lever, and
insert the pin in the lever (7) and the control (fig. 1-58).
Figure 1-58.
Power Turbine Stator Feedback Control Assembly,
Second View.
Install the Tube Assembly (In-Line Pressure Fluid Filter to
the Electromechanical Fuel System). Put one end of the tube
assembly (1) on the tee (3) at the filter (4), and the other
end of the tube assembly on the reducer (6) at the fuel system
(7). Then connect one tube nut (2) to the tee, and the other
tube nut (5) to the reducer (fig. 1-59).
53
OD1708
Previous Page
