Figure 1-56. Inlet Guidevane Feedback Control Assembly, Second View.

Installation of the Forward Engine Module And Accessory Gearbox of the
Page Navigation
52

Install the Power Turbine Stator Feedback Control Assembly.

Position this control (1) by the feedback control cylinder

(3). Put the control end (4) and two washers (5) on the pin

(6), and install a new cotter pin (7) in the retaining pin.

Then align the control with the slot (8) in the bracket (2),

move the nut (9) above the bracket, and slide the control in

the slot; screw the nut down on the control, and tighten the

nut against the bracket (fig. 1-57).

Figure 1-57.

Power Turbine Stator Feedback Control Assembly,

First View.

OD1708

Index