Figure 1-54.
Plenum-To-Engine Plain Seal, Second View.
Install the Inlet Guide Vane Feedback Control Assembly.
Put
the control (1) in place on the powerpack with the short-
booted end (3) near the shaft (4), push in the button (5) on
the pin (6), and remove the pin. Then align the hole in the
end of the control (1) with the hole in the lever (7), and
insert the pin (6) to secure the control to the lever. Next
slide the control in the slot on the bracket (2), and place a
lockwasher (8) between the nut (9) and the top of the bracket.
Install the nut on the end of the control, and connect the nut
(10) to the adapter (11) (fig. 1-55).
50
OD1708