Figure 1-47.
Tube Assembly (No. 5 and 6 Bearing Feed).
Install the Tube Assembly (No. 2 and 3 Bearing Feed). Put new
seals (2 and 3) in the tube nuts (4 and 5) and set the tube
(1) in place at the pump (6) and housing (7).
Connect the
tube nut (4) with the elbow (8), and at the other end of the
tube, connect the tube nut (5) with the adapter (9) (fig.
1-48).
Install the bearing feed tube assemblies clamp
according to TM 9-2350-264-20-1.
Install Tube Assembly (Bottom of Inlet Guide Vane Actuating
Cylinder). Place new seals (6 and 9) in the tube nuts (5 and
7) and position the tube (1) under the strut (10).
Loosely
connect the tube nut (5) to the tube and the tube nut (7) to
the elbow (8).
Now tighten the tube nut (5) and nut (7).
Position the clamp (4) across from the clamp (11), and install
and tighten a new nut (3) and screw (2) through the clamps
(fig. 1-49).
45
OD1708
Previous Page
