Install the Tube Assembly (No. 1 Bearing Feed). You install
this tube assembly by putting new seals (6 and 10) in the tube
nuts (3 and 7) and setting the tube assembly (1) in place at
the pump (5) and housing (9).
At one end of the tube
assembly, connect the tube nut (7) to the nipple (8), and at
the other end of the tube assembly, connect the tube nut (3)
to the nipple (4); tighten both tube nuts. Place a new strap
(2) around the tube, pull the strap tight, and cut off any
extra length of the strap above the connection (11) (fig.
1-41).
Figure 1-41.
Tube Assembly (No. 1 Bearing Feed).
Install the Tube Assembly (Forward Reduction Gearbox Oil
Feed).
When installing this tube assembly, you start by
putting new seals (8 and 11) in the tube nuts (6 and 9) of the
tube. With the new seals installed, you connect the tube nut
(9) to the nipple (10), and at the other end of the tube,
attach the tube nut (6) to the tube (7).
Tighten both tube
nuts (6 and 9).
Then place the two clamps (4) on the tube
(1), put one screw (3) through the clamp and bracket (5), and
install the nut (2).
Put the other screw (3) through the
clamps (4 and 12) and install the other nut (2) (fig. 1-42).
41
OD1708