Install the Tube Assembly (Electromechanical Fuel System to
Bottom of Inlet Guide Vane Actuating Cylinder).
To install
this tube assembly, put new seals (7 and 13) in the tube nuts
(5 and 11).
Then put the tube assembly (1) in place and
connect the tube nut (5) to the tube (6). At the other end of
the tube assembly, connect the tube nut (11) to the adapter
(12); use a 11/16-inch crowfoot wrench to tighten it.
Next
place the clamps (4 and 14), on the tubes, across from each
other and install the screw (3) and new nut (2) in the clamps.
Install a new seal (10) in the tube nut (8) and connect the
tube nut to the adapter (9) (fig. 1-36).
Figure 1-36. Tube Assembly (Electromechanical Fuel System to
Bottom of Inlet Guide Vane Actuating Cylinder).
Install the Tube Assembly (Oil Pump Return to Oil Cooler-
Forward).
Start this installation process by placing the
filter element (2) in the nipple (7) and installing a new seal
(5) on the tube nut (3).
Then put the tube assembly (1) in
place on the two nipples (4 and 7), tighten the tube nut (6)
on the nipple (7), and at the other end of the tube tighten
the tube nut (3) to the nipple (4). If you cut off any straps
during the removal process, install new straps on the tube
(fig. 1-37).
37
OD1708
Previous Page
