Connect the Maintenance Indicator Engine Wiring Harness (1).
Connect the P9 connector (2) to the oil temperature
transmitter (3), the P7 connector (4) to the filter bypass
pressure switch (5), and the P30 connector (6) to the pressure
switch (7) (fig. 1-31).
Connect the Electromechanical Fuel System Cable Assembly (8).
Connect the connectors P35 (11) to one speed pickup (12) and
P5 (9) to the other speed pickup (10), and the P33 connector
(13) to the electromechanical fuel system (14) (fig. 1-31).
Figure 1-31.
Engine Wiring Harness and Cable Assembly.
Install the Accessory Gearbox Hoses. Using new conical seals
(1 through 4) install the accessory gearbox hoses (5 through
8) (fig. 1-32).
Remove the Forward Engine Overhead Support.
To remove the
support, remove the two pins (1) and use the hoist to lift the
support off the mounts (2) and set it on the floor.
Then
remove the chain hoist (3) from the link, remove the hoist
hook from the link, and stow the hoists and the support (fig.
1-33).
33
OD1708