Install the Tube Assembly (Electromechanical Fuel System to
Top of Inlet Guide Vane Actuating Cylinder). To install this
tube assembly, put new seals (7 and 10) in the tube nuts (5
and 8). Then put the tube assembly (1) in place and connect
the tube nut (5) to the adapter (6). At the other end of the
tube assembly, connect the tube nut (8) to the adapter (9).
Next place the clamps (4 and 11) on the tubes across from each
other, and install the screw (3) and new nut (2) in the clamps
(fig. 1-35).
Figure 1-35. Tube Assembly (Electromechanical Fuel System to
Top of Inlet Guide Vane Actuating Cylinder).
36
OD1708
Previous Page
