Figure 1-64.
Apply shortening compound on three new packings (6 and 7), put
two packings (6) on the couplers (8 and 9) and one packing on
the tube (2), and connect the couplers (8 and 9) for the tube
(1). At the other end of the tube, install two screws (10) in
the tube and the tank assembly.
Then, you must remove the
screw (11) and nut (12) from the clamp that holds the tube
(3).
Then put the screw in the bracket (14) and the clamp
(13), install a new nut (12), and tighten the nut.
Install
the plug (4) on the switch (15) on the tank (5) (fig. 1-65).
Figure 1-65.
58
OD1708