o Loosen the screw in the coupling sprocket and remove the four
screws, flat washers, and lockwashers that secure the hydraulic
motor to the conveyor drive-end section. Remove the motor from
the conveyor drive-end section and coupling sprocket. Remove the
key from the motor shaft.
With all the components removed during the removal process, inspected and
defective components replaced, the installation process can begin. To
install the conveyor hydraulic system components, you must reverse the
removal procedures using new packings and lockwashers.
Figure 30.
Conveyor Hydraulic Hoses and Fittings.
8.
Removal, Disassembly, Assembly, Installation,
and
Adjustment
of
Backup Hydraulic System Components.
You will begin this procedure with the hoses and connecting parts. The
safety requirements are the same. Removal of the backup hydraulic system
components can be accomplished using the following procedure:
NOTE:
All items refer to Figure 31.
32
OD1703
Previous Page
