and torque the new nuts to 170 - 190 inch-pounds. Then hook
the two latches (11) on the maintenance stand (fig. 1-5).
Install the Valve and Adapter.
Apply antiseize compound to
the three bolts (14). Then, using the three bolts, install a
new gasket (12) and the valve and adapter (13) in the forward
module (1) (fig. 1-5).
Figure 1-5.
Mating the Forward and Rear Modules.
Install the Module Bracket.
To install this bracket (1),
raise the jack (2) and install the two-bolts (3) (fig. 1-7).
Then lower the lifting sling until the cables (1 and 2) have
some slack and remove the sling's hook (3) from the pin (4).
Next remove the pin (5) from the sling's shackle (6), the
shackle from the block, and install the pin in the shackle.
Now you can remove the sling (7) from the hoist hook (8) and
store it (fig. 1-6).
9
OD1708