Figure 1-6.
Removing the Forward Module Lifting Sling.
After you have removed the lifting sling, apply antiseize
compound to the three bolts (4) and install the bracket (1) on
the engine (5), using the three bolts to secure it (fig. 1-7).
Figure 1-7.
Installing the Module Bracket.
Install the Power Turbine Stator Cylinder Assembly.
Wrap
antiseizing tape on the threads of the elbow (3) and adapter
(4) and install them in the cylinder (1). Then, you screw the
connector (2) in the piston (5) and pull the piston out all
the way. Next, you must screw the connector (2) to the length
A, and the plate (6) to length B, as noted on the tag by
whoever removed the cylinder (fig. 1-8).
After you have positioned the connector and the plate,
position the cylinder (1) on the lever (7), install the
cylinder pin (8), and put the control assembly end (9) and two
washers (10) on the pin.
Then put a new cotter pin (11) in
the hole of the cylinder pin (8) (fig. 1-8)
10
OD1708