Figure 1-9.
Power Turbine Stator Cylinder Adjustments, First View.
To adjust the cylinder plate (1) so it aligns with the holes
(2 and 3), you must pull the cylinder (4) down to the plate
(1). Then put the shank of a twist drill (5) in the hole (2)
of the lever (6) and lower the hole of the block (7).
Next
loosen
the
nut
(8),
turn
the
plate
clockwise
or
counterclockwise until it is firmly against the end of the
cylinder (4) when the holes (2 and 3) align; remove the twist
drill. Then you must move the cylinder (4) all the way up and
tighten the nut (8) against the plate (1) (fig. 1-10).
NOTE:
Make sure the plate does not turn when tightening the nut
against the plate.
12
OD1708
Previous Page
