M2/M3 BFV: HULL POWER DIST SYSTEM - OD1606 - LESSON 1/TASK 1
FIGURE 25.
REMOVING THE SHUNT FROM THE SUPPORT.
Now position leads 1W1B4 and 1W15E2 on to terminal 1A2K1A1, and
install the washer, lock washer, nut, and dust cap. Then install the
screw on the clamp.
If the winterization kit is installed, reinstall the battery
compartment
heat
exchanger
assembly
following
the
procedures
contained on page 30-106 of TM 9-2350-252-20-1-5.
If the
winterization kit is not installed, position the cover over the power
control compartment and install following the procedures contained in
paragraph 4a on page 10 of this task.
Finally, install the vehicle ground cable.
The procedures for
installation are contained in paragraph 4a on page 10 of this task.
Unstow the driver's seat and squad seat number four (if installed).
Conclude installation by placing the FIRE SUPPRESSION switch to the
AUTO position.
This completes the procedures for removing and installing the battery
STE-M1/FVS shunt. In the paragraphs that follow, the procedures for
removing
28