Figure 29. Removing the Relay From the Support

M2/m3 Bradley Fighting Vehicle: Hull Power Distribution System
Page Navigation
32

First, install the relay, two screws, washers, and new locknuts on

the support. Now reinstall jumper 1W33, lead 1W3E1, washer, new lock

washer, nut, and dust cap on terminal 1A2K1A2. Next, reinstall lead

1W15E2 and lead 1W1E4, washer, new lock washer, nut, and dust cap on

terminal 1A2K1A1 and remove tag.

Then install the screw on the

clamp.

After leads 1W15E2 and 1W1E4 have been reconnected, install the

diode, lead 1W1E5, washer, new lock washer and nut on terminal

1A2K1X2. Then install the diode, lead 1W1E3, washer, new lock washer

and nut on terminal 1A2K1X1.

Use the procedures listed in paragraph 4a on page 10 of this task and

reinstall the power control compartment cover and the vehicle ground

cable. Unstow the driver's seat and, if installed, squad seat number

four.

Finally, place the FIRE SUPPRESSION switch in the AUTO

position.

This completes the procedures for removing and installing the master

battery switch relay. In the paragraphs that follow, the procedures

for removing and installing the volts gage will be discussed.