M2/M3 BFV: HULL POWER DIST SYSTEM - OD1606 - LESSON 1/TASK 1
This
completes
the
procedures
for
removing
the
battery
jumper/conductor bus.
The procedures for reinstalling the battery
jumper/conductor bus will be covered in the following paragraphs.
While reading through these paragraphs on the reinstallation of the
battery jumper/conductor bus, refer to figures 18 and 19.
To install the battery jumper/conductor bus, first, install jumper
1W33, lead 1W2E1, washer, lock washer, and nut on terminal 1A2CB1-1.
Now install jumper 1W33, lead 1W3B1, washer, lock washer, nut, and
dust cap on terminal 1A2K1A2. Then install the screw on the clamp.
FIGURE 19.
REMOVING JUMPER 1W33 FROM
TERMINAL 1A2CB1-1.
Next, position the power control compartment cover and install four
spacers, new lock washers, and screws to secure the cover.
Now
install the vehicle ground cable following the procedures cited in
paragraph 4a on page 10 of this task. Now unstow the driver's seat
and, if installed, squad seat number four.
Then position the FIRE
SUPPRESSION switch to the AUTO position.
This completes the procedures for removing and reinstalling the
battery jumper/conductor bus.
In the paragraphs that follow, the
procedures for removing and installing the battery simplified test
23
Previous Page
