M2/M3 BFV: HULL POWER DIST SYSTEM - OD1606 - LESSON 1/TASK 1
Remove screw (10) (figure 18) from the clamp (11) and discard lock
screw.
Now remove the dust cap (12), nut (13), lock washer (14),
washer (15), lead 1W3E1 (6), and the jumper 1W33 (7) from the
terminal 1A2K1A2 (8).
This time, DO NOT discard the lock washer.
After lead 1W3B1 is removed, remove the nut (4) (figure 19 on the
following page), lock washer (5), washer (6), lead 1W231 (7), and
jumper 1W33 from terminal 1A2CB1-1 (2). Be sure to tag the lead and
DO NOT discard the look washer.
First, remove the screw (10) (figure 18) from the clamp (11) and
discard the lock screw. Now remove the dust cap (12), nut (13), lock
washer (14), washer (15), lead 1W3E1 (6), and jumper 1W33 (7) from
terminal 1A2K1A2 (8) on the relay (9). This time DO NOT discard the
lock washer. After lead 1W3E1 is removed, remove the nut (4) (figure
19 on the following page), lock washer (5), washer (6), lead 1W2E1
(7), and jumper 1W33 (1) from terminal 1A2CB-1 (2). Be sure to tag
the lead and DO NOT discard the lock washer.
FIGURE 18.
REMOVING LEAD 1W3E1 AND
JUMPER 1W33 FROM TERMINAL
1A2K1A2.
22
Previous Page
