M2/M3 BFV: HULL POWER DIST SYSTEM - OD1606 - LESSON 1/TASK 1
Once 1W15E2 and 1W1E4 have been removed from terminal 1A2K1A1, remove
the screw (4) (figure 21), lock washer (5), washer (6), and lead
1W16E1 (1) from terminal 1A2R1-2 on the shunt (3).
Again, do not
discard the look washer.
Now remove screw (9) (figure 22 on the following page), look washer
(10), washer (11), and lead 1W14E2 (7) from terminal 1A2R1-1 (8). Do
not discard the lock washer.
FIGURE 21.
REMOVING LEAD 1W16E1 FROM 1A2R1-2.
At this point in the removal procedures, separate the three locknuts
(14) (figure 23 on the following page) and washers (15) from the
three mounts (13). Discard the locknuts. Now tilt the support (12)
up and pull forward.
Once the support has been removed, remove two screws (3) (figure 24
on page 27), lock washers (4), washers (5), and the following leads
from the shunt terminals:
(1) 1W1E1 (6) from terminal 1A2R1-1 (7)
(2) 1W1E2 (8) from terminal 1A2R1-2 (9)
25