LESSON
PRACTICE EXERCISE
The following items will test your grasp of the material covered in this lesson.
There is only one correct answer for each item.
When you have completed the
exercise, check your answers with the answer key that follows. If you answer any
item incorrectly, study again that part of the lesson which contains the portion
involved.
1.
When loading or unloading ammunition, which of the following sections is used
as a staging area for ammunition transfer?
A.
Drive.
B.
Center.
C.
Take-up.
D.
Dead end.
2.
An override safety (ON/OFF) switch is incorporated in the conveyor assembly.
On which of the following sections is this switch is located?
A.
Drive.
B.
Center.
C.
Take-up.
D.
Dead end.
3.
Prior to starting any maintenance procedures on the conveyor assembly, the
MASTER switch must be in which of the following positions?
A.
On.
B.
Off.
C.
Hold.
D.
Standby.
4.
You must remove the conveyor supports. The conveyor assembly must be in which
of following positions before the supports can be removed?
A.
Mid.
B.
Stowed.
C.
Standby.
D.
Deployed.
45
OD1737
Previous Page
