LESSON
PRACTICE EXERCISE
ANSWER KEY AND FEEDBACK
Item
Correct Answer and Feedback
1.
D. Dead end.
The dead end sections, one at each end of the conveyor assembly, are
the only stationary sections.
Thereby, the only sections that can be
used as a staging area for ammunition transfer. (Page 3, para 1)
2.
C. Take-up.
In addition to providing a safety (ON/OFF) capability for the conveyor
assembly, this switch also provides an outside the vehicle shut off
capability.
Thereby, it is located near the door on the take up
section. (Page 3, para 1)
3.
B. Off.
The MASTER switch must be in the OFF position to ensure that no
electrical power is going to the conveyor assembly.
This serves two
purposes: the equipment cannot be operated by mistake, and the risk of
electrical shock is eliminated while performing maintenance on the
conveyor assembly. (Page 4, para 3)
4.
B. Stowed.
To ensure that injury to personnel and equipment does not occur, the
conveyor must be stow in accordance with TM 9-2350-267-10 prior to
removing the conveyor supports and support brackets. (Page 6, para 3)
5.
B. 4.
Because of the weight and size of the conveyor assembly and support
stand, four people are required to safely remove them.
(Page 31,
para 2)
48
OD1737
Previous Page
