M2/M3 BRADLEY FIGHTING VEHICLE: TURRET - OD1609 LESSON 2/TASK 2
(3)
Removal of the 25mm HE Ammo Forwarder.
Remove four screws attaching the
forwarder to the chute. Then remove the forwarder from the chute.
(4)
Removal of the TOW Control Box.
Step 1.
Remove the annunciator.
These procedures, when needed, can be found on
page 5-120 of TM 9-2350-252-20-2.
Step 2.
Remove two screws and washers attaching the tow control box to the
support.
Then remove the tow control box and bracket from the support.
Step 3.
Remove plug 2W5P2 from jack 2A5J1, located behind the tow control box.
(5)
Removal of the Gun Elevation Drive Motor.
Step 1.
Remove the 25mm gun barrel.
These procedures, when needed, can be
found in TM 9-2350-252-10-2.
Step 2.
Manually traverse the turret to 3200 mils.
These procedures, when
needed, can be found in TM 9-2350-252-10-2.
Step 3.
Manually elevate the 25mm gun to maximum elevation.
These procedures,
when needed, can be found in TM 9-2350-252-10-2.
Step 4.
Remove plug
2W305P1
from
jack
2A202J1
located
underneath
the
gun
elevation drive motor.
Step 5.
Remove the cotter pin, washer, pin, and clevis from the brake assembly
handle on the gun elevation drive motor. Discard the cotter pin.
Step 6.
Remove the locknut, screw, and two washers (located on top of the gun
elevation motor) from the motor guard. Discard the locknuts. Remove two screws,
lockwashers, washers (located under the gun elevation motor) from the motor guard.
Then remove the guard from the motor. Discard the lockwashers.
CAUTION
Failure to remove the screws without supporting the motor
can cause damage to the equipment.
78
Previous Page
