M2/M3 BRADLEY FIGHTING VEHICLE: TURRET - OD1609 LESSON 2/TASK 2
Step 11.
Adjust the gun elevation drive brake linkage.
These procedures, when
needed, can be found on page 7-8 of TM 9-2350-252-20-2-2.
Step 12.
Adjust the gun elevation drive variable resistor.
These procedures,
when needed, can be found on page 7-20 of-TM 9-2350-252-20-2-2.
(3)
Installation of the TOW Control Box.
Step 1.
Install plug 2W5P2 into jack 2A5J1, located on the back to the TOW
control box.
Step 2.
Apply primer and then sealant to the threads of the two screws that
will attach the TOW control box with bracket to the support.
Install the TOW
control box with bracket, two washers and screws onto support.
Step 3.
Install the annunciator.
These procedures, when needed, can be found
on page 5-120 of TM 9-2350-252-20-2-2.
(4)
Installation of the Weapon Control Box.
Step 1.
Install the weapon control box, three washers, and new locknuts on its
support.
Step 2.
Install plug 2W4P2 onto jack 2A4J2, located on the back of the weapon
control box.
Step 3.
Install plug 2W3P2 onto jack 2A4J1, located on the back of the weapon
control box.
(5)
Installation of the 25mm HE Ammo Forwarder.
NOTES
Install the HE
forwarder
with
the
handle
facing
the
gunner's seat.
Install the screws on
the
forwarder
beginning
with
the
upper right position.
Step 1.
Apply primer and sealing compound to the threads of the four screws
that attach the forwarder to the chute. Install the forwarder and one screw onto
the chute. Then install the three remaining screws onto the chute.
83
Previous Page
