thread shows on the studs between the mounting flange of the pump (1)
and the nuts (2 and 3)(fig. 23).
Figure 1-23.
With the nuts loose, you remove the pump (1) by turning it
counterclockwise and lifting it off the mounting flange
(6).
Once you have removed the pump, set it on a flat
surface (fig. 1-23).
With the pump removed, remove and
inspect the packing on the mounting flange for cuts, chips,
and flat spots, replace the packing as required.
Place the cover (1) from the ground hop parts kit on the
mounting flange (2) and turn the cover clockwise until the
three studs (3) are in the slots and tighten the three
screws (5)(fig. 1-24).
CAUTION
ELECTRICAL PLUG CONNECTORS IN THE GROUND HOP KIT MUST BE
CONNECTED TO THE CORRECT RECEPTACLE CONNECTORS ON THE
DISCONNECT PANEL. MAKE SURE THE CONNECTOR PINS AND KEYWAYS
(10) LINE UP.
PINS WILL BEND IF THE WRONG PLUG CONNECTOR
IS FORCED INTO THE WRONG PANEL CONNECTOR.
27
OD1709