Figure 1-16.
Plenum-to-Engine Plain Seal.
Remove the Screen Assembly (Engine Air Inlet).
You start this
removal process by removing the intake cover (1) from the screen (2)
and disconnecting plug connector 3W105-P34 (3) from the temperature
rotor sensor receptacle connector J34 (4) (fig. 1-17).
Perform this next step only if two bolts (5) hold the screen assembly
in place.
Remove the bolts (5) from the screen rim (8) and remove the screen
from the inlet housing (9) (fig. 1-17).
Figure 1-17.
Screen Assembly (Engine Air Inlet).
14
OD1707
Previous Page
