Figure 1-20. Tube Assembly (Bottom of the Inlet Guide vane Actuating Cylinder).

Figure 1-19. Tube Assembly (Top of the Inlet Guide Vane Actuating Cylinder).

Figure 1-21. Tube Assembly (N0. 2 and N0 3. Bearing Feed).

Removal of the Accessory Gearbox and Forward Engine Module of the AGT
Page Navigation
17

Figure 1-20. Tube Assembly (Bottom of the

Inlet Guide Vane Actuating Cylinder).

Remove the Tube Assembly (No. 5 and No. 6 Bearing Feed). To remove

this tube assembly, disconnect the tube nut (2) from the elbow (3)

at the engine oil pump (4) and remove the conical flared seal (5).

Then, you disconnect the tube nut (6) from the tube (7) at the

regenerator housing (8), and remove the tube assembly (1) and the

conical seal (9) (fig. 1-22).

Remove the Tube Assembly (No. 4 Bearing Feed).

removal process by removing disconnecting the tube nut (2) from the

elbow (3) at the engine oil pump (4) and removing the flared conical

Then at the other end of the tube assembly (1),

disconnect the tube nut (6)

Western Governors University

Privacy Statement
Press Release
Contact

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business