M2/M3 BRADLEY FIGHTING VEHICLE: TURRET - OD1609 LESSON 1/TASK 2
Step 25.
Install the AP ammo can door onto the AP ammo can and turn the handle.
WARNING
If the HE-AP selector switch is at HE with the AP ammo
loaded, rounds will fall long. Soldiers could be killed or
injured.
Check that the HE-AP selector switch is at AP
when the AP ammo is loaded.
Step 26.
Move the HE-AP selector switch to AP.
Step 27.
Stow the empty ammo cans.
These procedures, when needed, can be found
in TM 9-2350-252-10-1.
Step 28.
Close the turret shield door.
These procedures, when needed, can be
found on page 2-139 of TM 9-2350-252-10-1.
Step 29.
Move the TURRET POWER switch to ON.
Step 30.
Move the TURRET DRIVE SYSTEM switch to ON.
Step 31.
Release the turret travel lock.
These procedures, when needed, can be
found on page 2-141 of TM 9-2350-10-2.
Step 32.
Traverse the turret to 6400 mils.
These procedures, when needed, can
be found on page 2-152 of TM 9-2350-252-10-2.
d. Unload 25mm Gun Feeder. These subparagraphs will cover preparing the 25mm
gun feeder for unloading, removing the AP link eject chute from the 25mm gun
feeder, unloading AP ammo from the 25mm gun feeder, removing the HE link eject
chute from the 25mm gun feeder, unloading HE ammo from the 25mm gun feeder,
removing 25mm ammo from the 25mm gun feeder, and removing 25mm ammo from the 25mm
gun receiver.
(1) Initial Setup.
(a) Tools: Handcrank assembly, 14mm ratchet wrench, 3/8 inch flat-tip
screwdriver.
49
Previous Page
