from the cover (4). Then remove the cover and packing (5)
from the output shaft (6). Unscrew and remove the bolt (8)
from the cam (9).
WARNING
THE CAM (9) IS SPRING LOADED. USE CAUTION WHEN MOVING THE
CAM HEX (10) TO AVOID INJURING THE HANDS.
NOTE:
If the cam (9) detaches from the disconnect shaft (11) or
turns freely when moving the cam, you must notify your
maintenance supervisor.
Place the adjustable wrench on the cam flats (12) to help
move the cam hex to the opposite side.
Using a 13-
millimeter socket, hinged handle, and adjustable wrench,
move the cam hex (10) to the opposite side.
Then you
install and tighten the retaining bolt (8).
Make sure the preformed packing (5) is in the groove on the
cover (4), turn the cover notch (14) so it aligns with the
word OUT (14) on the output shaft (6), and install and
tighten the four screws (3) on the cover.
WARNING
TOOLS MAY SHORT ACROSS POSITIVE AND NEGATIVE CONDUCTOR
BUSES AND CAUSE BURNS OR ELECTRICAL SHOCK. TO AVOID INJURY
WHEN WORKING IN THE BATTERY COMPARTMENT, MAKE SURE THE
TOOLS DO NOT SHORT CIRCUIT THE BATTERIES.
e. Disconnect the Tank Power.
To disconnect the tank's power,
loosen the screws (2 and 3) on the bus (1), push the bus over the
terminal board (4), and tighten the screw (3) to hold the bus in
place (fig. 1-7).
7
OD1709
Previous Page
