Figure 1-17.
Reduction Gearbox Hose.
Install the Pressure Fluid Filter Double Angle Bracket. Place
the filter bracket (1) on the step plate mounting bracket (2),
and install and tighten the two screws (3) and washers (4) on
the bracket (fig. 1-18).
Figure 1-18.
Pressure Fluid Filter Double Angle Bracket.
When you have installed the pressure fluid filter double angle
bracket, then install the pressure fluid filter.
Start this
installation by placing two new packings (1) on the reducers
(2) and attaching the reducers to the filter (3).
Attached
the filter to the bracket (4) with the flow arrow (5) pointing
toward the fuel system (6) and install the two screws (7) and
washers (8).
Then connect the tube nut (9) to the tee (10)
and position the tube (11) and tee (10) on the fuel system (6)
and the filter. Loosely connect the nut (12) on the reducer
(13) and the nut (14) on the adapter (15).
After you have
properly positioned the tube and loosely connected both
18
OD1708
Previous Page
