Figure 45.
Continuity Test Lead AAA.
o Place the red probe on connector pin C and the black probe on pin
B of the hydraulic gage panel mounted connector (Fig. 46). Place
the conveyor control switch to the OUT position and test for
continuity with a multimeter.
If the multimeter remained on
infinity, the lead AAB between the conveyor control switch, the
hydraulic control panel, and gage panel connector must be
replaced. Assume the multimeter indicated 0 ohms, reconnect the
lead, assemble the hydraulic gage panel, and continue to
troubleshoot the system.
49
OD1703
Previous Page
