no. 3 (Item 2).
The extinguisher is located on the upper left
portion of the forward crew compartment bulkhead.
o You must now disconnect electrical harness connector (Item 7) from
the actuator of the crew compartment fire extinguisher no. 2 (Item
8). Facing to the rear of the crew compartment, this extinguisher
is located on the left side of the rear bulkhead.
o The connector (Item 9) must now be disconnected from the SCEA (Item
10).
o You must now open the cable straps in order to remove harness
12351501.
This task is accomplished by removal of a screw (Item
11), a flat washer (Item 12), and a lockwasher (Item 13) from each
of the 14 strap assemblies (Item 14), 12 strap assemblies (Item 15),
and two strap assemblies (Item 16). Remove only electrical harness
12351501 from the strap assemblies and keep the remaining harnesses
strapped to the cargo compartment bulkhead.
o The installation procedures are the reverse order of the removal
procedures.
Ensure new lockwashers are used in the installation
process.
o After wiring harness 12351501 has been installed, power restored,
tests completed, and the valve actuator locking pins removed, remove
the anti-recoil plugs.
Cable 12351754 is the last item of the crew AFES electrical wiring harness
system which is to be removed and installed.
Use Figure 36 and the
following procedures to guide you through the task of removing and
installing cable 12351754.
o Disconnect cable lead no. 10 (Item 1) from no. 6 circuit breaker of
panel no. 2.
o Now disconnect cable lead no. 415 (Item 2) from the air cleaner
blower motor relay.
o You can now remove cable 12351754 (Item 3) from the vehicle.
o Installation
procedures
are
the
reverse
order
of
the
removal
procedures.
54
OD1700
Previous Page
