M2/M3 BRADLEY FIGHTING VEHICLE: TURRET - OD1609 LESSON 3/TASK 3
FIGURE 34.
INSTALLING PLUG 2W202P1 TO JACK 2A200J4.
Whenever a corrective action has been taken in the test and inspection procedure,
test 2640 should be performed again to see if the symptom has been corrected. This
should be continued until a NO FAULTS FOUND condition exists.
When a NO FAULTS
FOUND message is displayed on the SETCOM during a repeat test, and the symptom has
been corrected, perform the follow-on procedures described in b(3)(a),(b),(c) and
(d) beginning on page 142.
4.
Test 2700 (25mm and 7.62mm Guns)
Test 2700 checks the initial status of all 25mm gun inhibit indicators, the 7.62mm
gun system completely, and the operation of the 25mm gun electronics by using the
STE weapon indicator. The test begins with performing message words, a STE hookup,
and continues with a cable check.
145
Previous Page
