M2/M3 BRADLEY FIGHTING VEHICLE: TURRET - OD1609 LESSON 3/TASK 3
(4)
If any faults are found during the STE hook up, refer to the symptom index
table in TM 9-4910-751-14-1, page 5-1.
(5)
If no faults are found during the STE self-test, hook up the gun simulator
(TM 9-4910-751-14-1) and remove the center turret floor plate (TM 9-2350-252-20-2-
2, page 4-22). Then enter 650 on the SITCOM and perform the test.
(6)
If any faults are found during test 650, read the SETCOM display. If the
SETCOM display does not read 65020 or 65033, refer to the symptom index table in TM
9-4910-751-14-1, page 5-1).
(7)
If no faults are found during test 650 and the SITCOM display does read
65020 or 65033, remove cable CX304 from cable CX307, remove adapter CA1507 from
cable 2W10, and remove adapter CA1508 from gun simulator TA1201.
Install cable
2W10 on gun simulator TA1202 and proceed with test 2700.
b.
Running Test 2700.
To run test 2700, enter 2700 on the SITCOM and wait for
the SETCOM response.
(1)
If the SETCOM displays a cable instruction message word number, refer to
the message word number index found on page 3-553 of TM 9-2350-252-20-2-1 and
follow the SETCOM instructions.
Assume, however, for the purposes of this
subcourse, that the SETCOM does not display a cable instruction message word
number.
(2)
If the SETCOM displays a fault message, it would be necessary to refer to
the fault number index found on page 3-605 of TM 9-2350-252-20-1. However, assume
again that no fault message is displayed.
(3)
The third possibility is that the display will show a NO FAULTS FOUND
message.
When a NO FAULTS FOUND message appears on the display, move the TURRET
POWER switch and MASTER POWER switch to OFF. Remove STE-M1/FVS from the diagnostic
panel. If required, install the center and right turret floor plates (TM 9-2350-
252-20-2-1, page 4-22).
Whenever a corrective action has been taken in the test and inspection procedure,
test 2700 should be performed again to see if the symptom has been corrected. This
should be continued until a NO FAULTS FOUND condition exists.
147
Previous Page
