Figure 18. Removing Lever and Spring

Figure 17. Removing Clamp And Yoke Assembly

Procedural Steps for Installing the Steering Shaft Assembly.

M2/M/3 Bradley Fighting Vehicle Steering System
Page Navigation
26

STEERING SYSTEM - OD160l - LESSON 1/TASK 1

Step 5. Remove yoke (11) from shaft (12) by removing locknut (13),

washer (14), yoke (11), two bearings (15), and woodruff key (16)(see

figure 17 on the previous page).

Step 6. Remove link (17) from lever (18) by removing cotter pin (19)

from screw (20).

Then, remove locknut (21), two washers (22), link

(17), and screw (20) from lever (18)(see figure 18).

REMOVING LEVER AND SPRING.

Remove lever (18) and spring (23) from shaft (24) by

removing cotter pin (25) from shaft (24). Then, remove locknut (26),

washer (27), lever (18), washer (28), spring (23), and retainer (29)

from shaft (24). Finally, remove nut (30) and screw (31) from lever

(18)(see figure 18).

Western Governors University

Privacy Statement
Press Release
Contact

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business