--
Insert switch S1 and O-ring with mounting hardware.
--
Put knob on the switch shaft and secure with
two
setscrews.
--
Connect remaining wires to S1 and remove tags.
--
Connect W1P1 to A2.
3-26. Filters FL1 or FL2 removal/replacement.
Removal.
--
Cut and remove sleeving from the terminal of FL1 or FL2
(26). Disconnect and tag wires.
--
To get inside the filter box, remove eight sets of
mounting hardware (27 and 28) and the cover (29).
Lay
cover aside.
--
Cut and remove sleeving from the terminal of FL1 or FL2.
Disconnect and tag wires.
--
Remove mounting hardware (30 and 31) and FL1 or FL2.
Replacement.
--
Install FL1 or FL2 with mounting hardware on cover.
--
Install a length of sleeving (MIL-I-23053/5, 0.25 dia.,
type I, black) over the wire leads to FL1 or FL2.
--
Connect wires and remove tags.
--
Slide sleeving over terminals and heatshrink.
--
Install cover with eight sets of mounting hardware.
3-27. ON/TRIPPED OFF Circuit Breaker removal/replacement.
Removal.
WARNING
Take off the AC power cable assembly from the PWR
connector.
47
OD1716
Previous Page
