Figure 1-19.
STE Preparations (Fourth View).
SETCOM must show NO FAULTS FOUND.
If the STE does not show
the correct display, the STE test set has a fault, and you
must notify support maintenance.
When you have completed all the tests successfully, you will
have correctly installed the STE test set and proven it
operational. Then, following the fault isolation chart, start
the primary test procedure using the STE test set.
Block 21.
After you prepare the STE for operation, follow the YES
flow line on the fault isolation chart to block 21, which gives you a
test number.
Follow the flowline to block 22.
After you have
entered the test number and press the GO key there are five possible
display messages the SETCOM could give:
General instruction (block 23).
Assemble, connect, disconnect, reconnect or remove (block 24).
Special instruction (block 26).
Fault (block 28).
See -20 Manual (block 30).
Block 23 to Block 25.
At this time follow the
YES flow line from
block 23 to block 25 (for actual troubleshooting
of the vehicle, the
answer depends on whether or not the SETCOM
displays a general
instruction).
The general instruction displayed
on the SETCOM asks
you to answer a question or tells
29
OD1711
Previous Page
