TROUBLESHOOTING THE HMMWV - OD1616 - LESSON 1/TASK 2
present, repair the body wiring harness from the neutral start switch
to the rotary switch, following the procedures in paragraph 4-62 of
the TM.
If the wiring harness is beyond repair, notify IDS/IGS
maintenance.
Step 6. Disconnect lead 11A at the rotary switch and check lead 11A
for battery voltage.
If voltage is present, replace the rotary
switch following the procedures in paragraph 4-7 of the TM.
FIGURE 3.
STARTING SYSTEM SCHEMATIC.
WARNING
The negative battery cable must be disconnected
prior to disconnecting any harness from the
protective control box, or injury to personnel
and/or damage to equipment may result.
50
Previous Page
